Thelin Co., Inc. Parlour pellet heaters combine state of the art technology (12V battery back-up options) with an environmentally friendly fuel source to produce the warmth and ambience of a wood fire. The simplified control system allows the user to set a temperature of Hi, Medium, or Low, fill the hopper with pellets and enjoy hours of trouble-free heat without having to "feed the fire" and/or make adjustments to complex control functions.

Safety features include automatic shutdown in case of blocked flue or high temperature conditions, automatic feed shutdown minutes after the hopper empties of pellets. Battery back-up option requires purchase of 12 volt battery and cable (circuitry built-in). Available in painted, chrome or gold trim - gold or chrome lid optional.

Specifications:

Height	42"
Weight	136#
Diameter	20"
Door Opening	14" x 9.5"
Exhaust Vent	3"
Exhaust to Floor	12.25"
Hopper Capacity	42#
Footprint	20" sq.

Performance:

Feed Rate:	5lbs. per hour on High (approx.) 1.5lb. per hour on Low (approx.)
Combustion Efficiency:	93.34% - 40,000 BTU hour on High
Heat Exchange Efficiency:	72.19% - 31,500 BTU hour on High
Heating Capacity:	1500 - 2500 sq. ft*
Power Consumption:	27 watts (.25 amps in 110V mode) (2.25 amps in 12V mode)
Energy Efficiency:	Cost per month to run (approx. $1.50 for electricity to run fan, feed motor)

*Heating capacity depends upon evnironment, insulation and quality of fuel - may vary from region to region throughout U.S.

Install and use only in accordance with manufacturer's installation and operating instructions. Contact local building officals about restrictions and installation inspection in your area. Alcove approved.

Model No.: Parlour 3000
Max. BTU Input 3000: 40,000

Listed room heater, pellet type - ASTM E 1509-93, ULC S627, applicable requirements of UL 1482- this pellet fired appliance has been tested and listed for use in manufactured homes in accordance with oregon administrative rules 924-23-900 through 814-23-909.

Clearances to Combustibles: Freestanding Heater

A. Unit to backwall	1.5" - 40 mm
B. Unit to sidewalls	5" - 125 mm
C. Unit to diagonal wall	5" - 125 mm
D. Unit to alcove ceiling	1" - 25 mm

Note: Install a non-combustible floor protector extending 6" in front of the appliance.
Vent type: Use only "L" pellet vent and connections. (3"/75 mm or 4"/100 mm)
Electrical rating: 120 volts/2.0 amps - 60 hz/1 phase

Caution: Special methods are required when passing chimney through a wall or ceiling. Refer to local building codes. Do not connect this unit to a chimney flue serving another appliance. For use with pelletized woods fuels only! Use of otherfuels will cause a hazardous condition. Note: Replace glass only with 5 mm cramic.

Warning: (Mobile Home) an outside air inlet must be provided for combustion and be unrestricted while unit is in use. The structural integrity of the mobile home floor, walls, ceiling and roof must be maintained.

Danger: Risk of electrical shock. Disconnect power before servicing unit. Do not run power cord under appliance.