The traditional look of the Avalon CambridgeTM DVS gas fireplace recalls a time when charm and function were the tradesman's mark. Made from a solid aluminum casting which allows for exceptional heart transfer, the Cambridge features a mantle accented by fluted channels and a gently curving arch that frames a large fire viewing area. The classic lines and hand-carved details tell a story of craftsmanship and comfort - a gracious invitation to delight in the beauty and warmth of realistic wood-like flames leaping over brightly glowing embers.
The Cambridge DVS is available for installation as a fireplace insert or as a zero clearance fireplace. It circulates warm air throughout your home using a quiet yet powerful built-in blower (yet heats even if the power goes out). The Cambridge achieves a remarkable 80 percent efficiency using either natural gas or propane.
Options
- 24 Karat Gold Plated Fanlight
- Cast Aluminum Fireback with brick pattern
- Wall Thermostat
- Remote Control Thermostat
| Fuel |
Variable Input (BTU/Hr.) |
Steady State Efficiency |
AFUE |
Heating Capacity |
Standing Pilot |
Room Fan |
Direct Vent |
| Natural Gas or Propane |
NG - Low 18,600 - High 31,000 LP - Low 16,000 - High 31,000 |
NG - 80% LP - 80.5% |
71.3% NG 71.8% LP |
Up to 1,500 Sq. Ft. |
Heats even when the powers out |
130 CFM Standard |
6 5/8" DuraVent |
Clearance to Combustibles
Please refer to fireplace insert clearance drawing below
Note: Improper installation of your gas appliance or failure to operate in accordance to the guidelines detailed in the Owner's manual may negate your warranty and endanger your home and family.
| Height |
34 3/4" (883 mm) |
| Width |
37"* (940 mm) |
| Depth |
19 3/8" (492 mm) |
| Vent Diameter |
6 5/8" (168 mm) |
| Unit |
165 lbs. (75 kg) |
*Depending upon the gas line and vent configuration, additional space may be needed to the side and the top of the unit.
|
|
|
| A=Face to Mantle |
17" (883 mm) |
| B=Face to top Facing |
12" (305 mm) |
| C=Face to Sidewall |
6" (153 mm) |
| D=Face to Side Facing |
6" (153 mm) |
| E=Hearth Extension Front |
12" (305 mm) |
| F=Hearth Extension Side |
0" |
|

Face Dimensions:
Cambridge Face Dimensions: 21 3/4" (552 mm) Tall x 33" (838 mm) Wide
Note: face sets 1 1/52" off the bottom of the unit.
Safety Testing
DIRECT VENT tested to ANSI Z21.44-1992 "Gas-Fired Direct Vent Wall Furnace Heaters(Omni Environmental Services, Inc.). Must be installed in accordance with all local codes, if any; if not, follow ANSI Z223.1 and the requirements listed in the owner's manual.
CLICK
HERE TO RETURN TO GAS STOVES AND INSERTS